Bang-olufsen BeoLink Passive - Setting-up Guide Bedienungsanleitung PDF herunterladen (Seite 4)

4

P L A C E M E N T

Planning your installation

The BeoLink Passive kit consist

of these two main parts:

– The BeoLink Passive receiver

(close-up operation panel

and receiver for the remote

control signals).

– The BeoLink Passive amplifier

box.

In the following we have listed

some advice and requirements

for the placement of the Beo-

Link Passive parts:

– Before you start make sure

you have all the necessary

cables, junction boxes,

screws, wall plugs, etc. If in

doubt, please contact your

Bang & Olufsen retailer.

– Do not connect any units in

your system to the mains,

before you have made the

connections.

– The units in the system must

all be placed in a dry place,

i.e. not outdoors (the cables,

however, may very well be

run outdoors).

■ The BeoLink Passive receiver:

– The receiver is designed to

function within a tempera-

ture range of 0–55°C (32–

130°F). If it is exposed to

higher or lower tempera-

tures, it may block the whole

system.

– Avoid placing the receiver in

direct sunlight or direct arti-

ficial light (e.g. a spotlight),

or near objects generating

electrical noise (e.g. dim-

mers), as this may reduce the

sensitivity of the remote

control receiver.

– The receiver cable supplied

is 5 metres (15'). If you need

a longer cable, you must use a

special low capacity cable.

This cable can be purchased

at you Bang & Olufsen

retailer (part no. 6270668,

length 15 metres – 50').

– Place the receiver so it can

receive the remote control

signals.

– If the receiver is placed next

to a door and in a suitable

height, you can easily switch

on or off on its close-up

operation panel, when

entering or leaving the room.

Likewise, if it is placed near

your telephone, you can

switch off the speakers while

you are on the phone.

12

3

If you have installed more units

throughout the house, make

sure that the remote control

can only activate one receiver

at a time.

Place the amplifier box on a

stable surface, e.g. on a non-

carpeted floor, a shelf, or at the

bottom of a cupboard.

Allow a space of approx. 5 cm

(2") above the amplifier box

for adequate ventilation.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare