Bang & Olufsen ML Gateway Installationsanleitung PDF herunterladen (Seite 7)

Preparing setup 7

Preparing setup

Conguration of IP address

When ML Gateway is delivered, the IP address is set to a static value. The IP address for ML Gateway is 192.168.1.10 (factory default).

Depending on the customer’s network settings, it may be necessary to change the IP address in order to t the network range. Follow the

procedure below:

- The rst step is to determine the network setup in the installation (IP address range, DHCP/non-DHCP). To do this it is necessary to access the

customer’s router.

- Connect the ML Gateway with an ethernet patch cable to a computer with ethernet connection and web browser. On older computer models, it

might be necessary to use a cross-wired ethernet patch cable.

- Set the IP address on the computer to a static value in the same IP address range as the default value, eg. 192.168.1.11, and the subnet mask to

255.255.255.0 (for information about how to access settings, refer to the desired OS below):

Windows XP:

- Start -> Settings -> Network Connections -> right-click on Local Area Connections and choose Properties -> choose Internet Protocol (TCP/

IP) and click Properties.

Windows Vista:

- Start -> right click on Network and choose Properties -> click Manage Network connections -> right click on Local Area Connection and

choose Properties (if a security message appears, choose continue) -> choose Internet Protocol Version 4 (TCP/IPv4) and click Properties.

Windows 7:

- Start -> Control Panel -> Network and Sharing Center -> Change adapter settings -> right click on Local Area Connection and choose

Properties (if a security message appears, choose continue) -> choose Internet Protocol Version 4 (TCP/IPv4) and click Properties.

MAC:

- Click on System Preferences -> click Network -> click Advanced -> click TCP/IP.

1 2 3 4 5 6 7 8 9 10 11 12 ... 57 58

Keine Kommentare

Bang & Olufsen ML Gateway Installationsanleitung Seite 7